Analysis of forming process for hot stamping fuel tank bracket of commercial vehicles

DOI

10.2991/978-94-6463-581-2_26How to use a DOI?

Keywords

Hot stamping; Lightweight; Fuel tank bracket; Forming analysis

Abstract

This article designs a commercial vehicle hot press forming ultra-high strength and lightweight fuel tank bracket, and formulates a hot press forming process route. The model design is carried out using Siemens NX software, and the forming process analysis is carried out using AutoForm software. The thinning, cracking, and wrinkling of the part during the hot stamping process are calculated, and the direction for improvement is determined. The fuel tank bracket structure is optimized, and the optimal structure and forming process plan are determined based on the static strength analysis and the optimized forming process analysis results, meeting the requirements of structural design and forming process.

Copyright

© 2024 The Author(s)

Open Access

Open Access This chapter is licensed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International License (http://creativecommons.org/licenses/by-nc/4.0/), which permits any noncommercial use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license and indicate if changes were made.

Download article (PDF)

TY  - CONF
AU  - Bo Li
AU  - Mingtu Ma
AU  - Jingwei Li
AU  - Shiquan Ren
AU  - Jian Ai
PY  - 2024
DA  - 2024/12/07
TI  - Analysis of forming process for hot stamping fuel tank bracket of commercial vehicles
BT  - Proceedings of the 7th International Conference on Advanced High Strength Steel and Press Hardening (ICHSU 2024)
PB  - Atlantis Press
SP  - 215
EP  - 220
SN  - 2590-3217
UR  - https://doi.org/10.2991/978-94-6463-581-2_26
DO  - 10.2991/978-94-6463-581-2_26
ID  - Li2024
ER  -